I've had some interest in this, but it would require me to dismantle it (at least partially). Anyone any advice on how to do that? I'm presuming that the track is bonded with 3M 5200 which I'm told will release if heat is applied.
Anyone been through it?
Re: Harken Roller Furler - complete headstay
[Re: Michael L]
#16574 11/07/1509:03 AM11/07/1509:03 AM
The foil sections have sleeves to join the sections. Only the screws should be secured with Red Locktite. Not that hard to remove. You will need a new head stay since the one with the drum was shortened. The installation guide is probably available online. I didn't look though.
My goal is the sell the furler and headstay as a complete assembly (I have another headstay with a TuffLuff). My goal is to take apart enough to enable me to get it into my minivan to transport it. I'm hoping that all I need to do is remove a couple of sections to allow a bend in the headstay