We are parting out hull #62. I have everything except a rudder ( I have the rudder but you don't want it.), and no #2. Sails are old.

I will list parts with photos in this thread as I get them together. Let me know if you need something soon and I will try to prioritize.

First up, primary winches. Arco #45 self tailing. These have the Barient 25 bolt pattern. Purchased in 2003, used for 4 seasons. $500 each, $900 for the pair OBO plus shipping.

Mark Schnitzler
St. Louis, MO area
314-541-1636
mark@markschnitzler.com

Galley door/cabinet. Has been restored. Resurfaced with white oak veneer. Has some nice figure in it. $250 + shipping OBO.

I could use the door for the starboard side door/cabinet.

Exactly which door do you mean?

My J30 is a 1979 model. There is a cabinet door like the one pictured on both the port and starboard side. I could use a replacement for the starboard side door.

I have it. Most call it a liquor cabinet. Ned‮s a bit more restoration work. My veneer job is peeling just a bit. Want to fix that before I pass it on. I will get back to you soon.

Sounds good. Keep me posted!

If you are parting the boat out, I am interested in an upper and lower lifeline. Looking for the continuous ones, from bow to stern without the gate.

I have continuous lifelines. The boat was always freshwater but they are original equipment, almost 40 years old.

Given their age, what would you want for them?

Not much. When do you need them?

Boom. In good shape but for paint scratches. It is rigged for outhaul (which is 3 or 4 to one, not sure which), and 2 reefs. I used one as a flattening reef and usually left the other off the sail. $800 OBO plus shipping from St. Louis MO area.

Tiller. Mahogany and ash. HAs a nib for a auto helm. Grain filled epoxy finish. Needs a final finishing for UV protection. $200 OBO plus shipping.

Harken windward sheeting traveler system. 27mm high load with high beam track. 3:1 system. Installed 2003. Used 4 seasons. Good condition. If you don't have one of these you don't know what you're missing. Here's one for less than half price. $500 OBO plus shipping.

Someone asked about the top step. Lost your email. Can you contact me again. Have some pics. Want to make sure you really want it before I take it off.

Would you happen to have a mainsail cover? Mine is repairable, but if yours is in good shape, I'm interested. Thanks!
Bill Veno
Waltzing Matilda

Maybe. I'll look. If I do, it's green with my sail number in red. And it doesn't wrap around the mast.

do you still have the winches?

do you still have the stove and all of its parts hoses and tank, I also need new teak hand rails, do you have them?

It doesn‮t need to wrap around the mast since I flake my main on the boom. My cover is basically a rectangle with clasps and ties.
Thank you! Bill

I made new hand rails last summer. You can have my old ones no charge. I will be in Newton for Easter. I can bring them with me if you want them

Winches are spoken for.

I may have the stove but not the tank. Interested?

Hi Mark,
Just following up on the mainsail cover (sort of fell off the radar screen there for a bit). Did you determine if yours is in OK shape - and, if so, how much you'd want for it? Thanks!
Bill Veno

Haven't found it yet. I know I have it, just not sure where it is. I will look some more.

Jib furling?

Also, i'm having a bugger getting my tach to work. I'd be interested in the tach and the sender for it.

Vee-Berth fiberglass shelves - port and starbord?
George

What are the sails like?

George: I have original v birth shelves. Will likely get them out this fall. Will contact you when I do.

Pabs: The main is pentax with full battens. Was used for six seasons, maybe 100 times. Was stored inside. Good condition but has some significant stains.

162.5 was used 9 seasons. No delamination. It's OK.

155 was only used 30-40 times. IN very good condition.

How much for the 155?

How much for the boom you show above? Are you still looking for $800?

$800 plus shipping.

$500 plus shipping for the 155.

How clean are the cushions? Pix? Is the folding prop in good shape?

Cushions are gone. Prop is in very good shape. Was referbed by Martek and just a few 10s of horse on it since.

Hi Mark, By chance is the stem head fitting available? If so, How much would you like for that?

Mark,

Is the 155 still available? Please excuse the questions, but can it be used on a roller furling and a fractional rig? What material is it? I've got a 155 carbon fiber that came with my boat that is at the end of its life.

Do you have the hatches by chance? All 3 of mine leak, and all 3 are broken to varying degrees.

Sorry, I should have updated this listing. The boat is sold and in the process of being merged with hull number 83 to make one good boat.

All good, and thanks for the update!

Hello -

I am looking for a swim ladder and an anchor hatch cover (if it is solid).

Are these available?

Sorry. Boat is sold. Everything is gone.