Can someone tell me the type or product number of the cutlass bearing I should order and where I can order it by email in the US. I have a 3/4 inch shaft on a 1980 J30, hull 237? Thanks mucho.
Herb Clifton, hull 237, Black Knight, Panama
Herb - I have a 1" shaft on Rhapsody so can't help with the part number. I think Charlie Stoddard just bought a new cutlass bearing for Falcon. I'll email him and ask him to post info here.
Posted By: Phil
Re: Cutlass Bearing - 03/04/13 01:26 AM
My Cutlass Bearing needed to be replaced last year, and I needed to have one machined.
Posted By: cstoddard
Re: Cutlass Bearing - 03/04/13 12:12 PM
Herb
I had mine replaced several years ago The yard ordered it so I'm not sure of the part number let me check with them and see if I can get you a part number
I've attached the Durmax spec sheet for cutlass bearings. The 1" shaft on Rhapsody uses bearing code BACK (Metallic) or BABE (non-metallic) and was cut to length. Once the proper size is known for the 3/4" shaft, you can use this to search for a vendor to buy from.
Bronze SleeveNon-Metalic Sleeve
Posted By: Conundrum
Re: Cutlass Bearing - 03/04/13 02:20 PM
I replaced my Cutlass bearing on my 1984 1 in shaft
Invoice says Betta Bearing $72.66
I think they would have yours.
Marine Machining and Manufacturing., LLC
33475 Giftos
Clinton Twp, MI 48035
586-791-8800
FAX 586-791-8803
www.marinemachining.com
Posted By: Rhapsody #348
3/4" Shaft: Cutlass Bearing - 03/05/13 04:48 AM
Herb,
I found
this old post the indicates the outside diameter of the cutlass bearing for the 3/4" shaft is 1.25", which is the same OD that the 1" shaft has.
The cutlass bearing codes for the 3/4" shaft are:
Bronze Sleeve - ABLE
Non-Metalic Sleeve - ALDA
Posted By: Black Knight
Re: 3/4" Shaft: Cutlass Bearing - 03/05/13 06:56 PM
Thanks Bill and everyone .... I now know more about cutlass bearings than I ever thought I would .... I have an email request into one of the vendors mentioned in the posts and am waiting for a product number and vendor from one of the members of this forum. .... Herb Clifton
Posted By: Black Knight
Re: 3/4" Shaft: Cutlass Bearing - 03/05/13 07:08 PM
Changed my mine .... I just ordered it from West Marine from Bill's old post reference. Mission accomplished .... thanks mucho to everyone .... Herb Clifton