We're getting so close to sailing. I have installed the new Tacktick T104 system and use a Standard Horizon CP150 chartplotter. This is input to the NMEA IN interface. The NMEA OUT is then connected to terminal strip where the DSC Radio and the Autohelm and the PC with Nobletech software. That picks up all the data from the transmitters.
So far so good, as long as the waypoints are controlled from the GPS.
What I would like is to use the PC to input and control waypoint and route information to the system.
In the current configuration that is not working out.
My serial connections to the PC are on pins 2/5 going to the NMEA OUT at the terminal strip.
Suggestions?
Thanks
Last edited by Conundrum; 04/10/11 09:53 AM.
