Yes - we ran into the issue of constantly adjusting the downhaul for jibes, any time the guy is adjusted, etc, plus it's location means we have to disconnect it on every beat as it gets twisted around the jib sheets with the roller furling. However, I don't have any other deck hardware installed yet, so just trying to get a feel for the best methods others use, and then will make a decision once we are a bit more competent with the spinnaker.
The second set of blocks used near the stantion bases to keep the guy and sheet out of cockpit - do others jsut attach these to the rings on the stantion bases? Or would this apply too much pressure, and risk yanking the stantions out?
