I'm getting a lot of vibration at idle in neutral and at all speeds in gear.
I had the prop rebuilt and replaced the cutlass bearing three years ago, which helped with the vibration I was feeling then, but it has gotten worse.
I plan to re-check the shaft alignment, but I don't think that's the major problem since the vibration is just as bad in neutral.
I have observed a lot of movement in the motor mounts. They aren't cracked, but could just be fatigued after so many years (1985 model).
The only thread on this subject is from 2007, so there's a lot more wear from the ensuing years.
Has anyone tried replacing the mounts? The front ones are pretty accessible, but I can't figure out how you can get to the underside nuts on the rear bolts of the rear mounts.
Would appreciate any advice.
