no, but I went here (
http://www.profili2.com/eng/default.htm - and downloaded/installed the "light version")and made my own drawing and template in about 1/2 hour.
When you have installed the program, open it up. The initial Database of wings will open. Go to Management and choose New Airfoil. Enter the data points from the excel sheet in this post. Negative Y's will complete the full foil profile for the "lower" section.
Then go to "Ribs/Templates" and change the chord length to be 411 mm.
Print. Cut out and make template.
It may not be perfect, but it will follow the rules of the given data from the excel file and is far easier and more accurate than doing it by hand.
Jon
Margay
