Can someone with a few minutes, and knowledge, draw me up a rough sketch of the correct routing( sheaves, exit plates) that apply to each halyard? I searched and can't get an answer as to where the main halyard is suppose to exit the mast. My main exits at the upper most exit plate(middle) on the starboard side. And I don't have a spin halyard in the mast. I just have two jib halyards run over the sheaves beneath the forstay, and exiting the port exit plates. I think I have a topping lift exiting the forward most exit plate on the starboard side. And nothing exiting the aftward most plate on the starboard side.
[This message has been edited by MangoMadnesss (edited 08-14-2008).]
