|
M |
T |
W |
T |
F |
S |
S |
|
|
|
|
|
|
1
|
2
|
|
3
|
4
|
5
|
6
|
7
|
8
|
9
|
|
10
|
11
|
12
|
13
|
14
|
15
|
16
|
|
17
|
18
|
19
|
20
|
21
|
22
|
23
|
|
24
|
25
|
26
|
27
|
28
|
29
|
30
|
|
31
|
|
|
|
|
|
|
|
|
There are no members with birthdays on this day. |
|
|
Forums28
Topics4,054
Posts19,272
Members1,062
| |
Most Online1,909 Jul 28th, 2026
|
|
|
|
Joined: Jun 2014
Posts: 1
Forum Newbie
|
|
Forum Newbie
Joined: Jun 2014
Posts: 1 |
Hi everyone: Thanks to the generosity of a very good friend, I have the good fortune to race on a J/30 in Penobscot Bay near Northport, Maine. I have the even better fortune of being able to drive. I'm looking for advice on the best place to sit or stand so I can see the Tell-Tales on the jib. I think I have a tendency to sail too high and pinch.
|
|
|
|
|
Joined: Apr 2007
Posts: 493
Governor at Large
|
|
Governor at Large
Joined: Apr 2007
Posts: 493 |
I have an "old" cockpit. I find that the best place for me to sit is on the windward side, aft of the primary winch, outboard, with my back near the lifelines, with tiller extension in hand. I can see the tell-tales well, and if everybody on the rail is sitting out, the water up ahead.
If I have a main trimmer, she'll sit in front of me.
To tack, I often stand up and step over the tiller.
Dennis Bartley Planxty, s/n 23994 hull 205
|
|
|
|
|
Joined: Apr 2000
Posts: 679
Governor at Large
|
|
Governor at Large
Joined: Apr 2000
Posts: 679 |
On the 'new' cockpit, sit outboard of the coaming. On all styles, wood foot braces at the edge of the cockpit seats are a help. If you trim your own main it helps to have one foot on either side of the traveler. To tack, push to tiller to leeward with extension, grab the wood handle while dropping into the cockpit, lift and pass behind the back, then slide out and switch to the extension on the new side. Have seen a few folks turn and face aft momentarily while switching sides.
|
|
|
|
|
Joined: Apr 2007
Posts: 493
Governor at Large
|
|
Governor at Large
Joined: Apr 2007
Posts: 493 |
Apparently, Bob and I tack differently... he's surely fast
Dennis Bartley Planxty, s/n 23994 hull 205
|
|
|
|
|
Joined: Oct 2009
Posts: 381
Senior Member
|
|
Senior Member
Joined: Oct 2009
Posts: 381 |
I do the same... windward side with a main trimmer/tactics in front of me.
|
|
|
|
|
Joined: Oct 2007
Posts: 162
Senior Member
|
|
Senior Member
Joined: Oct 2007
Posts: 162 |
Interesting... I tend to drive from the low side so that I can see the entire headsail and have the headsail trimmer down there with me. I leave the tactics and lookout to everyone else who are on the high side. But I'm not known as a fast boat so that might not be the best idea.
Dominique Labrosse Red Five, #92
|
|
|
|
|
Joined: Apr 2004
Posts: 457
Senior Member
|
|
Senior Member
Joined: Apr 2004
Posts: 457 |
I use the same position/technique as described by Bob R. I also will shift forward in very light conditions so that I am fully forward of the traveler (with no one sitting behind me). I find the boat moves better in light condition with all the weight out of the back of the boat.
|
|
|
|
|
Joined: May 2005
Posts: 74
Senior Member
|
|
Senior Member
Joined: May 2005
Posts: 74 |
For me it pretty much depends on the wind and tactical situation. When wind's low enough, I'm the first to go low (assuming there's nothing pressing upwind of me) and I'll drive from the low side on a start if I can be sure I've nailed the bargeline and there's nobody above me. Once we need to flatten the boat, I'm on the high side just aft of the traveller. Tacking depends on the situation...I sometimes use a glimpse aft for a review of what's behind me, but most of the time I step over the tiller, seat-to-seat, facing forward. No matter how ya di it, they're a great bot to drive!
Doug Marshall Koeshtkah #207
|
|
|
|
0 members (),
134
guests, and
3
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|